DEMO ARENA / SAMPLE OPERATOR

Take a look around.

New here? Try this quick walkthrough
  1. Ice thickness: tap a point and change its sample reading. Try Start and Finish to see the two measurement stages.
  2. Flood log: choose a rink and activity, adjust the duration, then save.
  3. Inspection: check an item, or open Add note to flag an issue and explain it.
  4. Review: save your demo record and open it under Your demo records below. Switching workflows keeps your entries until you leave or reload.

This demo shows selected workflows. Customer accounts also include facility and staff management, refrigeration records and downloadable reports.

See readings on the rink.

These are sample measurements. Tap a point to change it, or switch to finish readings. The color ranges are an example guide, not an operating standard.

Ice thickness map

Tap a point to enter its reading. Next point moves down each column, then right: P01 → P12 → P19 → P02. Switch between start and finish measurements.

29 of 29 start readings entered

Select any numbered point on the map.

Point colors follow the thickness guide below; the outlined point is selected. All 29 start readings are required. Finish readings are optional.

Thickness color guide

Selected range: 1.50–2.00 inches (38.10–50.80 mm). Colors apply to each displayed reading.

Red · Very thin — review firstBelow 0.70 in
Orange · Below selected range0.70 to below 1.50 in
Green · Within selected range1.50–2.00 in
Blue · Above selected rangeAbove 2.00 in

Suggested ice maintenance · start readings

29 of 29 points assessed. Review individual low and high areas before planning work.

Orange · Below selected range

1 point: P04

  • Confirm the low areas against nearby points and the previous log.
  • Review shaving and water application with the lead operator. Build confirmed low areas according to the facility’s maintenance plan and recheck.

Green · Within selected range

28 points: P01, P02, P03, P05, P06, P07, P08, P09, P10, P11, P12, P13, P14, P15, P16, P17, P18, P19, P20, P21, P22, P23, P24, P25, P26, P27, P28, P29

  • Continue routine resurfacing under the facility’s operating plan.
  • Monitor consistency between points and remeasure after maintenance. Thickness alone does not describe surface condition.

Follow your facility’s approved operating and maintenance procedures. Green means within this selected thickness range.

Maintenance references

ORFA: The Anatomy of Skating Ice Maintenance · Jet Ice: Ice Making and Maintenance

Your demo records (0)

Stored only in this open page. The latest 20 demo records appear here.

Save a demo log above, then open it here to review its readings.

Picture this at your facility?

Let’s talk about a pilot with your team.

Email Mohamadmnaser234@gmail.comCopy this address into your preferred email app.